R A N G E H O O D
Model Number:
Manufacturer Number:
Size:
JXT5830
S26E30
30”
JXT5836
S26E36
36”
USER
G U I D E
TABLE OF CONTENTS
Safety Instructions....................................................1
Controls & Features...............................................2-3
Maintenance.........................................................4-6
Warranty..................................................................7
Form No. A/05/04 Part No. 8110P263-60 ©2004 Maytag Appliances Sales Co. Litho U.S.A.
CONTROLS & FEATURES
2
TOUCH CONTROLS & FEATURES
The standard Metal Filters are required to be cleaned frequently and as recommended in order
to maintain blower efficiency. If improperly maintained, residue from cooking will sift though
filters and cause damage to hood blowers and other sensitive components; and possibly clog
duct work and create a fire hazard.
CONTROLS & FEATURES
3
CONTROLS: FILTER CHANGE INDICATOR (CARBON FILTERS)
Filter Change Reminder (Carbon, if fitted):
When your hood is installed as a 'Purifying' (Ductless Recirculating) unit, it is fitted with a set of
Carbon Filters to purify exhaust and fumes from cooking, then re-circulate the air within the home.
These Carbon Filters are required to be replaced after every 120 hours of use. The Filter Change
Reminder function in the microprocessor needs to be switched on. The microprocessor in the
controls when set, will elapse and count usage time and indicate by a flashing
when carbon
filter replacement is needed.
Setting the Filter Change Reminder:
When Off, hold
The display will change from
for approx. 5 seconds.
Set Mode
(exhaust mode) to
, (purifying mode/
display from <--> to <C>
display <C> flashes
hold 5 secs.
carbon filters used) this indicates that the
elapse timer function is switched on and
Carbon Filters are used.
Filter Replace Indicator:
Change Filters
When the display
Carbon Filters require replacement.
starts flashing, the
Re-setting Function:
Once filters are replaced, with hood off,
To Reset
press and hold
hold for approximately 5 seconds until
on display disappears . The Filter
, the display will appear;
display from <C> to < >
hold 5 secs.
Change Reminder is now re-set and a new
120 hours elapse cycle is initiated.
MAINTENANCE
4
CLEANING
Surface Maintenance:
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive
detergent (e.g. Comet powder scrub, Easy Off oven cleaner), or steel wool/scouring pads which will
scratch and damage surface.
For heavier soil use liquid degreaser such as 'Formula 409' or 'Fantastic' brand cleaner.
After cleaning, you may use non abrasive stainless steel polish/ cleaners such as 3M or
ZEP, to polish and buff out the stainless luster and grain. Always scrub lightly, with
clean cotton cloth, and with the grain.
Metal Filters
The Metal Filters fitted by the factory are
intended to filter out residue and grease
from cooking. It need not be replaced on a
regular basis but are required to be kept cle
Filters should be cleaned after every 30
hours of use.
Remove and clean by hand or in
dishwasher. Spray 'Formula 409' or
equivalent degreasing detergent and leave
to soak if heavily soiled.
Dry filters and re-install before using hood.
Replacing Metal Filters
Should filters wear out due to age and
prolonged use, replace with following part
number:
Hood Model:
Part No.
Filters in pkg.
JXT5830
JXT5836
ZOF-MO52
ZOF-MO53
2
3
Also replace damaged filter that has
punctured or broken mesh, bent or broken frame.
Metallic Filters Dimensions
8.15” x 9.75”
207 mm x 248 mm
|